Table of Contents
Advertisement
1.
Access the Web interface for the Sender unit and login as "Administrator".
2.
Click the Functions tab.
3.
Locate the Serial over IP group and change the RS-232 settings to match the
settings of the RS-232 device that is being used. In this case, we need to use the
settings from Table 2.1
4.
Make sure that the Enable Serial over IP box is checked.
Important
If Enable Serial over IP is not checked, then RS-232 pass-through will be
disabled.
5.
Click the Save button in the lower-right corner of the Serial over IP group.
page | 36
Using RS-232
Advertisement
Table of Contents
