Table of Contents
Advertisement
When connecting USB devices to the HD KVM over IP, the functionality is similar to that
of video and RS-232. There are two USB modes available in multicast mode: Active per
request mode and Active on link mode.
For an example, we'll begin with the last diagram and connect another keyboard and
mouse device to Receiver R1. This will allow us to control the computer from two separate
locations.
Figure 2.9 - Using USB devices under multicast mode.
HDMI Out
07
1.
Make sure the desired Sender and Receiver units are set to multicast mode. Refer to
Configuring Multicast Mode
2.
Access the Web interface for the Sender unit.
3.
Click the Functions tab.
Locate the USB over IP group and make sure the Enable USB over IP box is
4.
checked. This is the default setting. See the illustration on the following page.
USB under Multicast Mode
Receiver unit
HDMI Out
Receiver unit
07
Sender unit
05
if necessary.
page | 41
Sender unit
HDMI In
USB cable
07
HDMI In
USB Control
LAN
Sender unit
HDMI In
09
Advertisement
Table of Contents
