Table of Contents
Advertisement
Locate the USB over IP group and make sure the Enable USB over IP box is
4.
checked. This is the default setting. Note that in unicast mode, the Operation Mode
is automatically set to Active on link and cannot be changed.
Make sure that the USB Mouse Mode is set to High Resolution. This is the default
5.
setting. Use Compatibility mode only if using additional KVM switchers or other
devices within the system that causes the mouse to behave erratically.
6.
Click the Save button within the USB over IP group, then click the Reboot button at
the bottom of the page.
7.
Connect the USB host (e.g. computer) to the USB port on the Sender unit.
8.
Connect a USB device (keyboard and/or mouse) to a USB port on the Receiver unit.
Up to 4 USB devices can be connected per network in unicast mode.
9.
The keyboard and mouse (or other USB device) can now be used from the Receiver
unit.
Important
When enabling or disabling USB over IP, the Save and Reboot buttons must
be clicked to apply changes.
page | 40
USB Control
Advertisement
Table of Contents
