3.
Click the Network tab.
4.
Click the Unicast button under the Network Mode window group. When selected,
the Unicast button will be highlighted in blue.
5.
Click the Save button in the lower-right corner of the Network Mode group.
6.
The following message will be displayed, at the top of the page, indicating that the
casting mode has been applied to the Sender or Receiver unit.
Click the Reboot button at the bottom of the page. If the Reboot button is not clicked,
7.
the following message will be displayed, indicating that the unit must be rebooted.
8.
Repeat steps 1 - 7 in order to configure the Sender unit for unicast mode.
Important
When switching between unicast and multicast modes, both Sender and
Receiver units must be set to the same mode.
Unicast & Multicast Modes
page | 24