CONTENTS Introduction Operation Notes Features Panel Layout Panel Descriptions Connecting And Operating The 2x2 Switcher for HDMI 1.3 RMT2-IR Remote Control Description IR Channel Configuration 10 Specifi cations 11 Warranty...
The Gefen 2x2 Switcher for HDMI 1.3 Gefen’s 2x2 Switcher for HDMI 1.3 is equipped with two HDMI inputs and two HDMI outputs. Two inputs accommodate the simultaneous connection of up to two high defi...
OPERATION NOTES READ THESE NOTES BEFORE INSTALLING OR OPERATING THE 2X2 SWITCHER FOR HDMI 1.3 • Display information (EDID) is needed by the source to determine the capabilities of the connected display. This is especially important for HDMI 1.3 sources because without the right information in the EDID none of the features for HDMI1.3 will be enabled.
FEATURES Features • Switch easily between any two HDMI™/DVI sources • Outputs are mirrored to two HDMI™/DVI displays simultaneously • Maintains high resolution video - beautiful, sharp HDTV resolutions up to 1080p, 2k, and computer resolutions up to 1920 x 1200 are easily achieved •...
PANEL DESCRIPTIONS Power LED Indicator This LED will become active once the included 5V DC power supply is properly connected between the unit and a open wall power receptacle. IR (Infrared) Receiver This receiver will accept command for switching between input HDMI devices using the included RMT-2IR remote control.
CONNECTING AND OPERATING THE 2X2 SWITCHER FOR HDMI 1.3 How to Connect the 2x2 Switcher for HDMI 1.3 Connect up to two HDMI source devices to the 2x2 Switcher for HDMI 1.3 using the supplied HDMI cables. Connect up to two HDMI capable devices to the 2x2 Switcher for HDMI 1.3 using the supplied HDMI cables.
RMT2-IR REMOTE CONTROL DESCRIPTION The included RMT-2IR remote control is used to switch between inputs on the 2x2 Switcher for HDMI 1.3. Only one input can be selected at a time and this input is then mirrored to the four HDMI outputs on the rear panel. Switching Press the 1 button to switch to HDMI input 1.
IR CHANNEL CONFIGURATION Why would I need to change the remote channel? In some instances, the 2x2 Switcher for HDMI 1.3 may use IR codes that confl ict with other IR remote control devices. The unit may switch inputs when another brand IR remote control is used or the RMT-2IR may cause other brand IR controlled devices to behave unexpectedly.
Page 12
IR CHANNEL CONFIGURATION 2x2 Switcher for HDMI 1.3 LED Indicators The 2x2 Switcher for HDMI 1.3 uses inactive LED and blinking LED combinations to indicate to the user which channel is currently active. The Currently Selected Input LED Indicators (Item 6 on page 4 and 5) are the two LEDs used to indicate the IR channel.
SPECIFICATIONS Video Amplifi er Bandwidth ............... 225 MHz Input Video Signal ................1.2 Volts p-p Input DDC Signal ................. 5 Volts p-p (TTL) Single Link Range ........1080p/60 12 bit color depth, 1920x1200 HDMI Connector ..............Type A 19 Pin Female Power Supply ....................