Table of Contents
Advertisement
Command
#get_usb_mouse
#get_video_allow
#get_web_port
#help
#reboot
#set_description
#set_discovery
#set_edid_copy
#set_gateway
#set_hdcp_allow
#set_ip_address
#set_ip_mode
#set_jumbo_mtu
#set_net_mode
#set_netmask
#set_pq_mode
#set_remote_udp_access
#set_remote_udp_ip
#set_remote_udp_port
#set_rx_id
#set_serial_allow
#set_serial_baud
#set_serial_bits
#set_serial_parity
#set_serial_stop
#set_showme
#set_telnet_access
#set_telnet_pass
#set_telnet_port
#set_telnet_welcome
#set_tx_channel
#set_udp_access
#set_udp_port
#set_usb_allow
#set_usb_mode
Description
Displays the mouse operating mode
Displays the Video-over-IP state
Displays the HTTP listening port
Displays a list of available commands
Reboots the unit
Sets the description of the Sender / Receiver unit
Enables or disables the discovery service
Enables or disables EDID copy (Rx only)
Sets the gateway address
Enables or disables HDCP-detection (Tx only)
Sets the IP address
Sets the IP mode
Sets the MTU mode
Sets the network casting mode
Sets the netmask address
Sets the picture quality mode (Tx only)
Enables or disables remote UDP access
Sets the remote UDP IP address
Sets the remote UDP listening port
Sets the ID of the Receiver unit (Rx only)
Enables or disables Serial-over-IP mode
Sets the baud rate for the serial port
Sets the data bits for the serial port
Sets the parity setting for the serial port
Sets the number of stop bits for the serial port
Enables or disables the "show me" feature
Enables or disables Telnet access
Sets the Telnet password
Sets the Telnet listening port
Sets the Telnet welcome message
Sets the video channel (Tx only)
Enables or disables UDP access
Sets the UDP listening port
Enables or disables USB-over-IP
Sets the USB operating mode
page | 64
Commands
Advertisement
Table of Contents
