Table of Contents
Advertisement
Waiting for video source - standby
Remote IP = Sender unit
7.
Make note of both IP addresses. These IP addresses can be entered in a Web
browser to access the built-in Web interface.
8.
See
Local Area Network (LAN) Connection (page 6)
in order to configure your PC and access the built-in Web interface.
9.
Set the video channel. By default, both the Sender and Receiver unit are set
to channel 0. See
10. Once both Sender and Receiver units are configured using the built-in Web
interface, the shielded CAT-5e cable, between the PC and the Receiver unit,
can be disconnected.
11. See
Supplementary Connections (page 14)
IR, RS-232, and audio cables.
Setting the Video Channel (page 18)
page | 13
Installation & Configuration
Local IP = Receiver unit
FW: V1.53H-Oct-24 779c
Local IP: 169.254.7.231
Remote IP: 169.254.6.250
ID: 001C9103C003
and follow steps 6 - 22,
for more information.
for instructions on connecting USB,
Advertisement
Table of Contents
