Table of Contents
Advertisement
Operating Notes
•
The
Gefen Syner-G Software Suite
that provides network configuration assistance and automatic download and
installation firmware upgrades for this product. Always make sure that the HD KVM
over IP is running the latest firmware.
•
The HD KVM over IP is compatible with the DVI KVM over IP, VGA KVM over IP,
DVI KVM over IP w/ Local DVI Output, and the HD over IP w/ RS-232 and 2-way IR
which allows these products to be connected within a single system.
•
Gefen highly recommends the use of the Syner-G software and Matrix Controller
(Gefen part no. EXT-CU-LAN) for setting up and controlling the operation of a
Video-over-IP network using these products.
•
Shielded CAT-5e (or better) cables should not exceed 330 feet (100 meters) between
the Sender / Receiver unit and the network.
•
By default, all Sender and Receiver units are set to channel 0.
•
This product does not support dual link resolutions.
•
By default, the source device will use the EDID from the display (or other sink device)
which is connected the Receiver unit. See
information.
•
If terminating network cables in the field, please adhere to the TIA/EIA568B
specification. See the
Important
The use of a Gigabit switch with higher than 8K "jumbo frame" capability is
required when connecting the HD KVM over IP to a network.
© 2015 Gefen, LLC. All Rights Reserved. All trademarks are the property of their respective owners.
Gefen, LLC reserves the right to make changes in the hardware, packaging, and any accompanying documentation
This product uses UL listed or CE-compliant power supplies.
is a free downloadable application from Gefen
EDID Management (page 47)
Network Cable Diagram (page 150)
HD KVM over IP is a trademark of Gefen, LLC.
without prior written notice.
v
for details.
Pb
for more
Advertisement
Table of Contents
