Housekeeping Connector Pin-Out - Alcatel-Lucent 1850 TSS-320 Turn-Up And Commissioning Manual

Tests and Measurements
............................................................................................................................................................................................................................................................
4. Housekeeping (HK) alarms check (if present)
Procedure
Refer to
HK connector location and pinout.
EML-USM — Select "External Points" from the "View" menu of EML-USM.
a. Connect one housekeeping input (HK_IN) alarm pin at a time to the HK-REF (pin
EML-USM — Configure the Housekeeping output (HK_OUT) alarm.
b. Connect the "Lamp block" between the N and P contacts of the couple of HK-
c. Select the HK_OUT to be tested and then, from the pop-up menu, select
d. Verify that the related alarm is present, by observing that the "lamp block" turns
Table 3-8 Housekeeping connector pin-out
............................................................................................................................................................................................................................................................
3 - 5 6
Figure 3-1 on p. 3-5
24) and check the alarm detection on the CT.
OUT signal to be tested (i.e., between HK_OUTN_1 and HK_OUTP_1).
"Configuration" and set "ON" the "External state" field; click on "OK."
ON; the alarm is also raised on the CT.
#Pin Signals
1
2 HK_OUTN_1
3 HK_OUTP_1
4
5 HK_OUTN_2
6 HK_OUTP_12
7
8 HK_OUTN_3
9 HK_OUTP_3
10
11 HK_OUTN_4
12 HK_OUTP_4
13
14
15 HK_IN1
16 HK_IN2
and Figure 27on page 72 and Table 10 on page 71
Description
# 1 Output; N wire
# 1 Output; P wire
# 2 Output; N wire
# 2 Output; P wire
# 3 Output; N wire
# 3 Output; P wire
# 4 Output; N wire
# 4 Output; P wire
# 1 Input
# 2 Input
Local testing and operating sequence
PN 8DG08136CAAA
Issue 1 March 2008
for