Alcatel-Lucent 1850 TSS-320 Turn-Up And Commissioning Manual page 60

Tests and Measurements
............................................................................................................................................................................................................................................................
Auto-negotiation
Frame length
Bandwidth
Optical interfaces (XFP) types (refer to
characteristics" (p. 4-16)
10 GbE XFP interface types (on PIM10GE)
........................................................................................................................................................................................................................
6
Check that all the frames received are the same of those transmitted and no alarms are
detected by the instrument for 5 minutes.
........................................................................................................................................................................................................................
7
Alarms detection — Perform the cross-connection described above:
From EML-USM, select "Equipment" -> "Data board Navigation," then insert login
•
and password. The Data CT starts.
– In the "1850TSS User Service Management.." window, double-click on the board
– Select a local port. From the pop-up menu (click on the right button of the mouse),
– In the "Ethernet port Configuration" window, select the "Configuration" tag and
– Select the port again. From the pop-up menu (click on the right button of the
Connect the pattern generator/error detector and check that the LOS alarm disappears
•
(green square) and that the on-board LED related to the 10 GbE port under test is
green.
Open the SONET loop to check the presence of the TSF alarm on the remote port, as
•
described in the following.
– Select a remote port. From the pop-up menu (click on the right button of the
– In the "Ethernet port Configuration" window, select the "Configuration" tag and
............................................................................................................................................................................................................................................................
3 - 3 4
for details)
(i.e., r1sr1/board#2). The local and remote data ports are displayed.
select "Configure Ethernet port."
set "Up" in "Admin. Status" field. Click on "OK."
mouse), select "Ethernet Port Properties." Open the "Alarms" tag, and check the
presence of the LOS alarm (red square).
mouse), select "Configure Ethernet port."
set "Up" in "Admin. Status" field. Click on "OK."
Local testing and operating sequence
OFF
1574 bytes
10%
Chapter 4, "SFP and XFP modules optical
B&W = 10Gbase-E / 10Gbase-S / 10Gbase-L
DWDM = APD for long haul
PN 8DG08136CAAA
Issue 1 March 2008