Table of Contents
Advertisement
Cable and fiber installation
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
1
Refer to the engineering job specification. Obtain the DS1/E1 cables per
"DS1/E1 cable assemblies" (p.
direction (IN or OUT of the bay) at each end. See
VLIU1 applications" (p. 3-5)
applications" (p.
Note:
OUT. Cable ends terminated using a RJ-45 connector will not need to be labeled using
the IN and OUT designation because both are supported by the connector.
........................................................................................................................................................................................................................
2
Connect the RJ-45 end of a single cable to the respective RJ-45 Receptacle on the access
panel on the front of the rack-mount Alcatel-Lucent 1850 TSS-5 shelf as shown in
Figure 3-1, "VLIU1 DS1/E1 access panel cable connectors" (p. 3-7) or Figure 3-2, "RJ-45
pin out for VLIU2/VLIU10 dual cable harness" (p. 3-8)
45 port assignments" (p. 3-8)
assignments" (p. 3-8)
........................................................................................................................................................................................................................
3
If necessary attach a 3" tie bar to the front of the Alcatel-Lucent 1850 TSS-5 shelf above
the circuit packs slots and just above the top of the VLIU. This will allow the front cover
to close.
........................................................................................................................................................................................................................
4
Route the cables toward the left along the tie bar and into the bay cable rack. See
Figure 3-6, "DS1/E1 cable routing for VLIU Paddle boards" (p.
Figure 3-1 VLIU1 DS1/E1 access panel cable connectors
DS1 connectors
ports 1-8
............................................................................................................................................................................................................................................................
365-372-403R5.1
Issue 1 November 2008
3-3). Label the cables, indicating bay and shelf, and
or
Table 3-4, "Dual harness DS1/E1 for VLIU2 and VLIU10
3-6)for associated color coding.
Blunt-end cables that are to be wire wrapped will need to be labeled IN or
and
Table 3-3, "Single harness DS1/E1 for
Figure 3-4, "VLIU2/VLIU10 E1 RJ-45 port
DS1/E1 cable installation
Table 3-2,
and
Figure 3-3, "VLIU2 DS1 RJ-
3-9).
3 - 7
Advertisement
Table of Contents
