Alcatel-Lucent 1850 TSS-320 Turn-Up And Commissioning Manual page 38

Tests and Measurements
............................................................................................................................................................................................................................................................
Check that the "free-running" indication is present in the timing reference block
•
dedicated to the internal oscillator G.783. If the "Hold-Over" indication is displayed,
first switch the equipment off and then back on again. Afterwards repeat all the
procedures.
........................................................................................................................................................................................................................
4
Select "Synchronization" -> "Set T0 Equal T4"
Check that the frequency counter reads a measured value of 2048 kHz ±4.6 ppm. To
•
perform this measure, the "Squelch T0/T4" must be deactivated (green color), by
selecting Synchronization -> T4 Configuration; in "Squelch T0/T4" field, set T0 =
G.813
SONET ports test
Purpose
Let through data to check if the ports are properly connected to the ODF.
•
Check PTx.
•
Check that ALS is working properly.
•
Test instruments
Note:
Craft Terminal (E)
•
Pattern Generator/Error Detector (A)
•
Power meter (B)
•
x dB fixed attenuator
•
Accessories
Note:
Single-mode or multi-mode single-fiber splices (I) or (Q), according to the interface
•
type
Craft Terminal cable (L)
•
Test Bench
Set up the matrix loop via software.
............................................................................................................................................................................................................................................................
3 - 1 2
See Table 3-1, "Instruments" (p.
See Table 3-2, "Accessories" (p.
Local testing and operating sequence
3-2).
3-2).
PN 8DG08136CAAA
Issue 1 March 2008