Table of Contents
Advertisement
D*AP4
Setup GUI – EVENTS – Events – Preset Events
A preset event is a group of presets you may load at one occasion to the On Air parameters of function
blocks. When executing such an event you may for example change the Equalizer, compressor and EQ
settings, by simply assigning the individual preset of your choice to the processing block or the system, to
an interface, to the routing, to the program path or even to the monitor output:
Here you have the possibility to reconfigure the D*AP4 completely, partially or to change a few audio
parameters marginally. Reconfigure also means you can use this part to create Events
which act like snap shots!
To create a new preset event you must press <create event>:
Some blocks have empty selection drop downs
because nothing is selected while others don't have
such drop down at all because no presets
exists there.
As an example you see here the pull down list
of all existing presets from the
Filter – Spectral Signature section:
......................
Event name
.
Use Settings from
On Air
.
Existing Event
67
[Snap 1]
A unique name to address this preset
event later in the action manager.
[ON Air / Existing Event / Empty]
The events manager will
all
On Air parameters
to
in
all
function blocks (that have been
selected via the "Include" check
boxes).
you will be asked from which event it
originated. The presets of the
selected event will be copied to the
new event and may be marginally
tuned afterwards to form a slightly
different event.
copy
new
presets
Advertisement
Table of Contents
