Table of Contents
Advertisement
D*AP4
Set up GUI – INTERFACES – SDI I/O interface – Local Routing
The SDI interface comes with a local routing matrix to shuffle audio signals from and to the system (device)
(i.e. to and from the central device router) and from and to the physical de-embedders / embedders.
The example below shows an example routing that sends signals 1:1 from the physical de-embedders
[INTERFACE – SDI IN G2 CH3 ... SDI IN G4 CH4] to the physical embedders [SDI OUT G2 CH3 ...
SDI OUT G4 CH4]. The signals from the physical de-embedders [SDI IN G1 CH1 ... SDI IN G1 CH4] are
sent to the device router [DEM 1 ... DEM4] while the device router outputs [SYSTEM – SDI Embedder
EMB 1 ... EMB 6] are routed to the first 6 SDI channels [SDI OUT G1 CH1 ... SDI OUT G2 CH2]:
You must use the scroll bar to navigate through the matrix. In the upper left hand corner you can select
between the ONAIR and the PRESETS view of the matrix. On the ON AIR page you will also see the
device signal labels (see ROUTING section further below for details).
Channel Linking
You may select cross points by hovering with the mouse over the little squares and select / deselect cross
points with a left mouse button click.
Mouse over
dark blue
orange
grey
red
.
An animated signal flow
[mono / stereo]
You can decide if the routing must be performed in mono or stereo mode
(where adjacent odd/even channels are routed at once).
Color codes of cross points:
Possible new cross point.
You are about to reconnect a cross point.
Cross point is not allowed (i.e. routing will cause a loop and will not
therefore be performed) or dedicated input is not activated.
You are about to disable a cross point.
will help you when navigating through the matrix.
27
Advertisement
Table of Contents
