Table of Contents
Advertisement
D*AP4
Setup GUI – connecting with the D*AP4
You must open a browser and enter the IP address of the D*AP4
into the URL field
and press <Enter>. The browser will retrieve the necessary information and open up the
entrance page:
The entrance page is the AUDIO PROCESSOR pane with its sub pane Overview. If you are returning from
other pages or if you reload your browser content (by pressing <F5>) it may show a different page due to
caching of the browser.
In the top section you see several bar graph displays for signal levels as well as for gain reduction display of
several function blocks.
On the following pages we will go through the various panes to perform the basic setup of the device.
You must set up the synchronization source. You may also give the device a name, tell it its location and
define an administrative contact which may be used by the monitoring system of your house (e.g. via SNMP).
You must set up the installed interface module and finally set the signal routing.
You will find those settings under the SYSTEM link.
14
Advertisement
Table of Contents
