Table of Contents
Advertisement
D*AP4
Setup GUI – AUDIO PROCESSOR - Setup
chain and are no longer causing a delay. However switching blocks on or off can cause clicks and
glitches, even in unaffected channels, as the latency compensation is recalculated.
Bit Transparency
1L/1R | 1L/1R
2L72R | 2L/2R
System Latency [ms]:
Base Latency
AES IN to AES OUT
Additional Latencies
Spectral Signature
Sample Rate Converter
Base latency consists of 1 ms Limiter Look Ahead Time and all system inherent
processing and input/output delays.
Activating sample rate converters will add additional latency (< 1ms).
Loudness Mode
Processing Bypass
Latency Management
Program 1
Program 2
Latency Mode
For non audio signals which may be appear at the input of a program
chain permanently or time by time you can select the behavior here.
[OFF / ON / AUTO]
[OFF / ON / AUTO]
You may force the DSP to pass through the audio stream untouched
in case there is encoded audio present. The AUTO mode is triggered
by the AES channel status.
44.100kHz
48.000kHz
4.26
2,9
0,21
41
In order to meet the regulations of
regions or countries you must select the
loudness control mode here.
Beside of the weighing curves several
measurement duration and loudness
ranges have bee defined. Some
regulations are based on the same
measurement (e.g. ITU BS.1770-2) but
defined in a different regional norm.
You must check with your local authority
for correct settings if you must comply
with regulations.
[ON / OFF]
You may turn the bypass ON/OFF from
here by activating the check box.
The bypass functionality may be
configured at the EVENTS >Actions
pane where the link will direct you to.
In a latency critical environment it might
be desirable to have the lowest possible
latency. So it is useful to actually bypass
a process that is not in use. In normal
operation, switching audio processing
modules on and off does not result in a
change of latency and thus does not
cause audible glitches or clicks.
Display of the actual latency
Display of the actual latency
[Minimal / Compensated]
"horizontal" compensation for one
program. Disabled audio processing
blocks are taken out of the processing
88.200kHz
96.000kHz
4.08
3.13
2,66
2,9
0,21
0,21
3.05
2,66
0,21
Advertisement
Table of Contents
