Table of Contents
Advertisement
Setup GUI – INTERFACES – AES I/O
Status
Input Signal Status
Input Signal Type
Settings
Enable Relay Bypass
Input Sample Rate
Converter
Output Channel
Status
Input Source Select
[green / red / yellow] The soft LED represents the status
[OK / Fail]
Fail = no carrier, unlock, cranky [too much jitter]
[Mute / PCM / Non PCM]
The Non PCM (e.g. Dolby encoded signal) status will be retrieved
from a logical combination of the Validity flag and the channel
status.
If one of the inputs is not assigned by the ROUTING section, its
status will not be incorporated into the System Status (see upper left
hand side above).
[ON / OFF]
For fail save operation bypass relays are provided to connect
AES IN / OUT in case of a power fail. One may enable such relay
manually here.
[ON / OFF]
For asynchronous sources it is possible to turn a SRC on.
If an SRC is turned on and the input status becomes Non-PCM, the
SCR will be turned OFF automatically in order to maintain the
original data structure of the encoded bit stream (e.g. Dolby E).
[Transparent / Prof PCM / Prof Non-PCM / Cons PCM /
Cons Non-PCM]
The channel status can either be transparent from the
input source of the D*AP4 or may be overwritten.
[BNC / XLR]
You must select here which input is in use.
(AES3id = BNC or AES3 = XLR).
24
D*AP4
Advertisement
Table of Contents
