Table of Contents
Advertisement
D*AP4
Setup GUI – ROUTING
This is the core of the D*AP4 as it defines the audio signal flow inside the device. It appears differently
depending on the type of optional interface boards installed.
Example without an interface board:
Each functional block of the device has a source label and a destination label. Additional
labels give an indication of the type of signal that is expected or issued by the respective function block
or I/O interface (e.g.
Top / horizontal (column headlines) = signal destinations
DSP
DELAY
AES
Left hand / vertical (line headlines) = signal sources
DSP
DELAY
AES
1L/1R
for AES or
2L/2R
[DSP 1 ... DSP 4]
The DSP inputs carrying the signal type labels 1L, 1R, 2L,
of the two programs 1/2 (see AUDIO PROCESSOR > Overview).
[DELAY 1 ... 4]
The four inputs of the extra delay lines of the D*AP4
[AES 1 ... 4]
The AES outputs of the device.
[DSP 1 ... DSP4]
The DSP outputs carrying the signal type labels
[DELAY 1 ... 4]
The four outputs of the extra delay lines of the D*AP4
[AES 1 / AES2]
The AES inputs of the D*AP4.
example for an SDI interface board:
for DSP 3/4 and so forth).
39
blue
signal
2R
1L, 1R,
2L,
2R
Advertisement
Table of Contents
