Table of Contents
Advertisement
The routing example on the left hand side shows that the AES inputs 1,2 are connected to the inputs
DSP 1,2 (label
1L/1R)
DELAY 1,2 and with the outputs AES 1,2 (label
the outputs AES 3,4 (label L,R).
Important Note! If a different optional interface board is installed the matrix will be expanded by the
pre-defined number of I/Os with their labels:
SDI
MADI
DANTE
4 Ch ANALOG I/O
AES
Setup GUI – AUDIO PROCESSOR - Overview
The overview shows the actual signal flow and the audio processor blocks, rendered by the DSPs.
The processing blocks in use, which may be activated from their individual setup panes, will be indicated in
green. I.e. blocks shown in grey are not activated by the user.
To navigate through the various processing blocks you may either click on the graphical block or use the
tabs provided in the navigation bars below the bar graph displays.
of the DSP. The outputs DSP 1,2 (label 1L/1R) are connected with the inputs
[O_DAP_SDI_a]
[O_DAP_MB_a /
O_MO_MM_a / _MS_a]
[O_DAP_DANTE_a]
[O_DAP_ADDA_a]
[O_DAP_AES_a]
L,
R). The outputs DELAY 1,2 finally are connected with
DEM 1 ... DEM 16 and EMB 1... EMB 16
MDIN 1 ... MDIN 8 and MDOUT 1 ... MDOUT 8
DTIN 1 ... DTIN 8 and DTOUT 1 ... DTOUT 8
ANL 1 ... ANL 4 and ANL 1 ... ANL 4
AES 1 ... AES 8 and AES 1 ... AES 8
40
D*AP4
Advertisement
Table of Contents
