Table of Contents
Advertisement
Getting Started – IP setup in general
The process of installing a D*AP4 into an IP network is as follows:
1. Ask the system administrator for a unique IP addresses of the network,
the netmask and gateway address
2. Assign the D*AP4 an IP address
You have 2 choices to assign the D*AP4 an IP address:
* From the serial console interface
* Via Web browser
Important Note! If you are not familiar with setting up devices for IP communication, we highly recommend
you consult your system service or IT department to assist you.
Getting Started – IP setup of the D*AP4
The tool to change the IP configuration of the D*AP8 can be selected via the console interface. You must
connect it with the PC via an USB A to B cable. This will install the driver for the built-in USB to serial
converter. Now you can open a terminal program. Here you must select the virtual COM port assigned by
the OS. The communication parameters are:
115200kBaud, 8, N, 1 no hand shake. Pressing <ENTER> will open the console menu:
[2014-08-22 12:01] Your choice:
Select item "2": <ENTER>
Current network configuration
IP Address:
Netmask ...:
Gateway ...:
Enter new IP address, press ENTER to cancel:
You must enter the new IP address (e.g.): "192.168.178.78" <Enter>
Enter new netmask, press ENTER to cancel:
You must enter the new netmask (e.g.): "255.255.255.0" <Enter>
Enter new gateway address, press ENTER to configure without gateway:
You may press <Enter> to skip this point or
You may enter the new gateway address (e.g.): "192.168.178.1" <Enter>
Important Note! The gateway entry is optional but you must take care that the gateway address matches the
network mask related to the device IP address! If you are not sure simply enter 0.0.0.0.
or leave it without an entry.
Changing Network configuration
Network configuration has been changed. Please reboot the device
to activate the new settings.
via console interface
–
10.110.24.128
255.255.0.0
10.110.0.1
8
D*AP4
Advertisement
Table of Contents
