Table of Contents
Advertisement
The steps to set up the EVENTS system are as follows:
1.
Define
2.
Configure
3.
Set up events
4.
Create actions
The following explanations refer to the factory default settings of the EVENTS system.
Setup GUI – EVENTS – Triggers – Sources – Remote Hotkeys
Hotkeys are the 8 buttons of an X*AP RM
to show up as active on the X*AP RM
The number of hotkey triggers is not limited. You may also add virtual hotkeys which can be used by a
graphical UI for example that may have more than 8 compared to the X*AP RM
Setup GUI – EVENTS – Triggers – Sources – Network
Network triggers are based on the EmBER+ protocol. See
The D*AP4 receives such triggers over the TCP/IP network. The triggers are issued by a remote device
or a broadcast automation system. You may assign these triggers to virtual panels, physical buttons or
play list events, of Ember+ enabled control instances.
- trigger sources
- triggers by logical combination of pre-defined trigger sources
- by selecting presets or GPOs or bypass blocks or measurement controls
- what should happen? Which trigger will launch which event?
remote panel. You may give them names and enable them
1
remote panels main operating menu.
1
#
The number of the Hotkey on the
X*AP RM
from left to right.
Label
Each Hotkey may have a label that
appears in the display of the
X*AP RM
button.
Enable
[ON / OFF]
If you turn it off the respective
Hotkey on the X*AP RM
panel becomes inactive - no label is
displayed and the button
background light turns off.
<remove>
will remove a line from the list. This
will automatically disable the
respective front panel button.
code.google.com/p/ember-plus/
#
The number of the network
trigger.
Label
Label of that network trigger.
It appears on the Configuration
pane as well as in the EmBER+
tree of the setup interface of a
control instance.
64
D*AP4
remote panel, counting
1
remote panel above that
1
remote
1
.
1
for details.
Advertisement
Table of Contents
