Table of Contents
Advertisement
Expert
Setup GUI – AUDIO PROCESSOR – Filter – Equalizer
The graphical EQ offers 5 bands. The characteristic of each band can be setup either left hand side of
the graph or alternatively for each band further below.
Program
Channel
Enable
Band 1 ... 5
[ON / OFF]
All parameters within the Expert section are duplicated in the
Signature and Spectrum graphs. They can be used to enter
numerical values directly. Changes are reflected in the graphs and
likewise in reverse.
Link Max Gain
Settings
Link Threshold
Settings
Band 1
Normalized
Signature level
Max Gain
Absolute Gate
Threshold
Band 2 ... 16
[Program1 / Program2 / Preset]
Selects the source for which the curve will be displayed.
This selection depends on the Voice Channel Mode
(see SYSTEM > Setup) and whether or not the channels are linked
for stereo operation.
[1L/1R, 2L/2R, 1L, 1R, 2L, 2R]
Depending on the program selected and the link status (see below
graph) the channel under control will be displayed here.
[On / OFF]
[OFF / Peak 1 / Peak 2 / Lo Shelf / Hi Shelf / Lo Cut / Hi Cut]
Filter characteristic will be selected by this pop-up:
48
D*AP4
[ON / OFF]
[ON / OFF]
[ON / OFF]
[-40.0 ... 0 ... 40.0]
[0.0 ... 3.0 ... 12.0
[-84.0 ... -80.0 ... 0.0]
similar parameters as Band 1
Advertisement
Table of Contents
