Table of Contents
Advertisement
Setup GUI – AUDIO PROCESSOR – Fail Over
Setup GUI – AUDIO PROCESSOR – De-Esser
Fail Over
MODE
Dual Mono
Fail Threshold (dBFS) [-80 ... -60 ... -40]
Fail Wait (s)
Fail Return (s)
Side Chain Filter
Link
De-Esser
Frequency (Hz)
Range (dB)
Filter Type
Q
Side Chain
Listen
44
D*AP4
The D*AP4 offers a fail over circuit
for automatic operation. It will
switch to 2L/R in case 1L/1R fails.
[FIX 1L/1R / FIX 2L/2R / AUTO]
In AUTO mode the switch over
happens in case of an input failure.
[OFF / AUTO]
A detector looks after the input signal.
If it is a left [L] or right [R] only it
converts that signal either to
[L/L] or [R/R].
RMS weighted input level for fail
detection.
[1.5 ... 10.0]
Elapsed time after fail detection
until the switch over will happen.
[0.0 ... 10.0]
Elapsed time after detection of a
proper input signal until the switch
back to the program input.
[OFF / ON]
A high pass filter (300Hz) and a low
pass filter (3000Hz) is applied to the
detector side chain (not the audio
path) to prevent hum and noise
from blocking fail over switching.
[Unlinked, Linked]
For stereo operation you may link
the setup parameters for both
voice channels.
[ON / OFF]
[1000 ... 3000 ... 16000]
[-20.0 ... 0.0]
[Peak / High Shelf]
[0.4 ... 1.0 ... 8.0]
[OFF / active]
Advertisement
Table of Contents
