Advertisement
4.17 REPLACING THE LCD COVER SUBASSEMBLY
1.
Confirm that the POWER switch is off.
2.
Insert the torsion bar (A) into the hole (B) provided in the top
cover. Make sure that the torsion bar is fully seated before
proceeding; the hooked portion should be positioned vertically.
FIGURE 4-28 Inserting the Torsion Bar
3.
Insert the short end of the hinge cover plastic cable shield (C)
into the main unit; the torsion bar must be seated in the hinge
cover between the cover and the shield. The hinge cover itself
should be seated on the two
FIGURE 4-29 Seating the Hinge Cover
Page 4-25
4.
Insert the long end of the hinge cover cable shield into the LCD
cover (E).
5.
Insert the short end of the LCD cover cable shield into the main
unit. The cable should be sandwiched between the two shields (F).
6.
While feeding the long end of the hinge cover cable shield into the
LCD cover, seat the LCD cover subassembly under the two dowel ends
(G).
FIGURE 4-30 Seating the LCD Cover
7.
Rotate the LCD cover assembly to a vertical position while
constantly maintaining pressure to prevent separation of the hinge
cover and the LCD cover. Insert and tighten down the two LCD cover
screws to complete the replacement procedure.
8.
As directed in part 4.16, reassemble the LCD cover.
MODEL:T1200H/HB
Page 5-1
5.1 SYSTEM UNIT
5.1.1 Inside the system unit
(A) LCD
(B) Top cover assembly
(C) Keyboard bridge
(D) Keyboard unit
pirot ends (D).
(H) 3.5-inch hard disk drive
(I) Built-in modem
(J) Hard disk control PCB
(K) System PCB
Advertisement
