Advertisement
The 1 key scrolls the display to the next page.
The 2 key scrolls the display to the previous page.
The 3 key returns the display to the DIAGNOSTIC MENU.
The 4 key erases all error log information in RAM.
The 5 key outputs error log information to a printer.
The 6 key reads log information from a floppy disk.
The 7 key writes log information to a floppy disk.
MODEL:T1200H/HB
Page 3-37
3.19 RUNNING TEST
3.19.1 Program description
This program automatically runs the following tests in sequence.
1. System test ( subtest number 01)
2. Memory test ( subtest number 01, 02, 03, 05, 06)
3. Display test ( subtest number 01 to 07)
4. FDD test ( subtest number 02)
5. Printer test ( subtest number 03)
6. Async test ( subtest number 01, 05, 08)
7. HDD test ( subtest number 01, 05, 08)
When running an FDD test, this system automatically decides whether
there are one or two
3.19.2 Operations
CAUTION: Do not forget to load a work disk. If a work disk is not
loaded, an error will be generated during FDD testing.
1.
Remove the diagnostics disk and insert the work disk into the
floppy disk drive.
2.
After pressing 6 and Enter to select from the DIAGNOSTIC MENU, the
following message will appear.
3.
Select whether to execute the printer wraparound test (Yes) or not
(No). Type the desired Y or N and press Enter key. (If Y is
selected, a wraparound connector must be connected to the printer
connector on the back of the unit.) The following message will
appear.
4.
Select whether to execute the test (Yes) or not (No). Type the
desired Y or N and press Enter Key. (If Y is selected, an R5232C
wraparound connector must be connected to the COMMS connector on
the back of the unit.)
FDDs.
Printer wrap around test (Y/N) ?
Async wrap around test (Y/N) ?
Advertisement
