Advertisement
5.
If it is not connected securely, reconnect it.
FIGURE 2-13 System PCB Connector Check
Page 2-41
PROCEDURE 5
LCD Module Connector Check
1.
Turn the POWER switch off and disconnect the ac adapter from the DC
IN 12V jack.
2.
Take out the LCD module (Refer to part 4.15.) and confirm that the
LCD cable is connected securely to the module.
3.
If the cable is connected securely, go to PROCEDURE 6.
4.
If the cable is not connected securely, reconnect it.
FIGURE 2-14 LCD Module Connector Check
Page 2-42
PROCEDURE 6
New LCD Cable Connection
1.
Connect the new LCD cable to the system PCB and LCD module.
2.
If normal operation is restored after replacing the LCD module, the
previous LCD cable was defective. Assemble the system.
3.
If normal operation is not restored, LCD module is probably
defective. Go to PROCEDURE 7.
Page 2-43
PROCEDURE 7
LCD Module Connection
1.
Connect a new LCD module and LCD cable to the system PCB.
2.
If normal operation is restored after replacing the LCD module, the
previous LCD module was defective. Assemble the system.
3.
If normal operation is not restored, system PCB is probably
defective. System PCB is probably defective. Refer to part 2.4.
MODEL:T1200H/HB
Page 3-1
3.1 GENERAL
Advertisement
