Advertisement
Page 3-22
Subtest 05
Card modem
Note:
If there is no modem card in the system, this test can
not be executed. Press the
that the Built-in modem power is on.
This test is used to check whether the data, which is
from the modem to the RS232C inside the system, is same
as the original data which had first been sent to the
modem
card.
Subtest 06
Card modem on-line test (Execution time: 10 seconds)
Note:
After the system is connected to the PBX, unless the
receive side is in the same status as the send side, the
test cannot be executed. Press the
confirm that the Built-in modem power is on.
In this test, first some data are sent to the modem card
from the RS232C inside the system, then the data is again
sent to the other system through the PBX (Private Branch
Exchange).
This test is used whether the returned data from the other
system are same as the original data.
Subtest 07
Dial tester test (Execution time: 60 seconds)
Note:
To execute this test, a dial tester must be connected to
the system.
This test is carried out by sending the pulse dial and
tone dial twice automatically.
[Pulse dial] : "1-2-3-4-5-6-7-8-9-0-1-2"
[Tone dial]
MODEL:T1200H/HB
Page 3-23
3.11 HARD DISK TEST
CAUTION: The contents of the hard disk will be erased when
03, 04, 06 and 08 is run. Before running the test, transfer the
contents of the hard disk on the floppy disk. This can be done
with the MS-DOS BACKUP command. After the test, enter the
MS-DOS FDISK command, which will set the partition. Then enter
the MS-DOS FORMAT command. (See the MS-DOS manual for details.)
Subtest 01
Sequential read (CYL.0-610,CYL.610-0) (Execution time: 7
minutes)
loopback (Execution time: 5 seconds)
Fn + SysReq key, then confirm
: "1-2-3-4-5-6-7-8-9-*-0-#"
Fn + SysReq key, then
subtest 02,
Advertisement
