Advertisement
1.
Confirm that the POWER switch is off.
2.
Remove the LCD mask from the LCD cover subassembly as directed in
part 4.14.
3.
Remove the four screws (A) on the LCD module (B).
FIGURE 4-23 Removing the LCD Screws
4.
Disconnect the LCD cable (C) from the LCD module.
FIGURE 4-24 Removing and Disconnecting the LCD Module
5.
To install a new LCD module, follow the above procedures in
reverse.
MODEL:T1200H/HB
Page 4-22
4.16 REMOVING THE LCD COVER SUBASSEMBLY
1.
Confirm that the POWER switch is off.
2.
Remove the LCD mask and LCD cover subassembly as directed in parts
4.14 and 4.15.
3.
Using tweezers or a fine-pointed instrument, peel off the hinge
label (A) and remove the two screws (B) that it conceals. Keep the
label in a clean place.
FIGURE 4-25 Removing the LCD Cover Subassembly Screws
Page 4-23
4.
Move the LCD cover subassembly (C) forward again to free it from
the unit's top cover (D).
FIGURE 4-26 Removing the LCD Cover Subassembly
5.
Remove the hinge cover (E) and the torsion bar (F) from the top
cover.
FIGURE 4-27 Removing the Hinge Cover and Torsion Bar
6.
Replacement procedures are described in part 4.18.
MODEL:T1200H/HB
Page 4-24
Advertisement
