Advertisement
FIGURE 4-4 Removing the Screws from the Top Cover Assembly
Page 4-4
5.
Open the LCD by sliding the two side latches (J) forward while
pulling the LCD upward.
FIGURE 4-5 Opening the LCD
6.
The top cover assembly can now be lifted and separated from the
base subassembly. Once the top cover assembly is separated from the
base subassembly it should be stood on its side to the left of the
unit.
FIGURE 4-6 Removing the Top Cover Assembly
7.
To reassemble the unit, remount the top cover assembly on the base
subassembly and follow the above procedures in reverse.
MODEL:T1200H/HB
Page 4-5
4.3 DISCONNECTING THE TOP COVER ASSEMBLY
1.
Confirm that the POWER switch is off.
2.
Remove the top cover assembly as directed in part 4.2.
3.
Lift the keyboard unit (A) out and place it in front of the unit.
4.
Disconnect the LCD cable (B) from the system PCB (C).
FIGURE 4-7 Disconnecting the Top Cover Assembly
5.
To install a new top cover assembly, follow the above procedures in
reverse.
MODEL:T1200H/HB
Page 4-6
4.4 REMOVING/REPLACING THE KEYBOARD UNIT
1.
Confirm that the POWER switch is off.
2.
Remove the top cover assembly and lift the keyboard unit out as
directed in part 4.2. It is not necessary to remove the keyboard
from the Base Subassembly
Advertisement
