Resetting The Lens To Home Position; Selecting A Test Pattern; Adjusting Boresight - Christie Roadie D4K40-RGB Installation And Setup Manual

Hide thumbs Also See for Roadie D4K40-RGB:

Table of Contents

4. Use the arrows to adjust the offset to display a square image on the screen, with minimal

projector aiming error.

5. To exit to the home page, select Back.

Resetting the lens to home position

Realign the lens to the home position after the lens has been offset and out of alignment.

1. Select LENS OFFSET.

You can also select MENU > Configuration > Lens Settings > Lens Offset.

2. To reset the lens to the default home position, select Enter.

3. To confirm the reset, select OK.

Many test patterns are available to assist with the configuration of the projector and to diagnose any

issues that may occur.

1. From the display panel, use the arrows to select Test Pattern.

You can also select the test patterns from MENU > Test Pattern or pressing N on the IR

remote.

2. Scroll through the list of test patterns.

3. Select the required test pattern.

4. To confirm your selection, select Enter.

The boresight adjustment balances the tilt of the lens mount to compensate for screen-to-projector

tilt.

Caution! If not avoided, the following could result in minor or moderate injury.

•

Do not look directly into the lens when the light source is on. The extremely high brightness can

cause permanent eye damage.

1. Close the shutter on the projector.

2. Unlock the three lens mount stabilization screws.

D4K40-RGB Installation and Setup Guide

020-102961-06 Rev. 1 (09-2022)

If printed, please recycle this document after use.

Installation and setup

Table of Contents