Port A Attributes Menu; Port A/B 24-Bit Address Identifier Submenu; Port A/B Sfp Module Parameter Submenu - Oracle StorageTek T10000 Operator's Manual

View or Change Configuration Settings
Intf FICON which enables the drive interface to run FICON protocol.
■
Defaults to the last saved selection.
In the online (view) mode, the current interface selection appears. You must switch to
the offline (change) mode to toggle the selection.
Procedure:
Do one of the following actions:
■
–
–

Port A Attributes Menu

The operator panel window shows either View PrtA ? (online) or Cfg PrtA ?
(offline).
Procedure:
Press Menu (No) to bypass or press Select (Yes) to enter submenus.
■
View or configure port attributes as defined in the following submenus.

Port A/B 24-Bit Address Identifier Submenu

The submenu is present when the drive is in the online state.
A=xxyyzzan or B=xxyyzzan 24-bit (6 hexadecimal characters) port identifier at
■
interface log on, plus connection type and speed.
xx = domain (00 in private loop or point-to-point)
yy = area (00 in private loop or point-to-point)
zz = 00 - EF (per connection type)
a = connection type (f: fabric, n: point-to-point, 0: public loop, v: private loop)
n = connection speed (varies by tape drive model)
A=........ or B=........ appears when the port is not logged onto an interface
■
Procedure:
Press Menu or Select to advance to the next submenu.
■

Port A/B SFP Module Parameter Submenu

Shows the Small Form-factor Pluggable (SFP) module information.
Operator panel window shows: nnGMM0nnnm, nnGSRnnnm, or nnGSMnn.nk.
■
Appears when an SFP module is present and readable:
4-4 StorageTek T10000 Tape Drive Operator's Guide
Press Menu (No) to bypass.
Press Select (offline) until desired option appears; then, press Menu to set and
initiate an IPL to load the desired firmware modules.
Manufacturing ships drive FRUs with the Intf FCP option
Note:
selected. When a defective drive in a FICON interface is replaced,
you must change the selection to Intf FICON. After IPL is complete,
the menu system displays the appropriate FICON related items.
Display is information only and appears in both online and
Note:
offline menus.