b.
Press Select to increment the character until the desired value appears, then press
2.
Menu.
Repeat step 2 for each character.
3.
Press Menu to advance to the next submenu; or, press Select to restart the change
4.
mode.
Drive Node Custom/Normal WWN Submenu
WWN Custom appears when either a Custom WWN is in use or is being created/edited.
Procedure:
Do one of the following actions:
■
–
–
WWN Normal recalls the stored Normal WWN from the drive EEPROM.
Procedure:
Do one of the following actions:
■
–
–
Serial Number Menu
Operator panel window shows S/N=zzzzzz (online only).
Identifies the manufacturing assigned serial number of the drive.
zzzzzz = the last six characters of the rear panel DMOD label.
This data is read from an internal EEPROM for online viewing only.
Procedure:
Press Menu or Select to advance to the next submenu.
■
Save Configuration Submenu
Operator panel window shows Save/IPL ? (offline only).
This submenu appears only if changes were made in any submenu.
Procedure:
Do one of the following actions:
■
–
–
Press Select to start the change mode.
This submenu only appears if either a Custom WWN is in
Note:
use or when one is being created/edited.
Press Menu to bypass to the next submenu.
Press Select to toggle the selection to WWN Normal.
Press Menu to recall the stored normal WWN and advance to the next
submenu.
Press Select to toggle the selection to WWN Custom.
Press Menu (No) to cancel changes.
Press Select (Yes) to save changes and initiate an IPL.
Saving CFG appears for 2 seconds after you press Select.
View or Change Configuration Settings
Menu System 4-15