Table of Contents
Advertisement
Messages
Table D–1 (Cont.) Operator Panel Display Messages
Display
Meaning
The tape drive cannot read code from the data
CodUpFail3
cartridge tape.
The data cartridge tape is not a code update
CodUpFail4
cartridge tape.
The tape drive cannot create (reformat or
DatCrFail1
reclaim) a cartridge tape.
The tape drive cannot create (reformat or
DmpCrFail1
reclaim) a diagnostic dump tape.
The tape drive cannot read the format of the
DmpCrFail2
data cartridge tape.
The tape drive cannot write diagnostic data
DmpWrFail1
onto the data cartridge tape, or the tape drive
cannot position the data cartridge tape.
There is no diagnostic dump data to process.
DmpWrFail2
xxxx:Dmp y
Alternates with *(an asterisk) after completion
of IPL, where xxxx = the FSC of last dump data
collected and Y = number of uncollected dumps
in non-volatile memory.
DumpAgain? alternating
The tape drive detected the same error within a
with Chk xxxx, xxxx is
minute.
an FSC. The Service
indicator is flashing.
The dump or event log is being transferred to
DumpToHost
the host; operator panel switches are locked.
The cleaning cartridge is used up.
Exp ClCart
The checksum does not match after an IPL.
Fix CfgErr
Init xxxx. xxxx is an
An initialization error occurred.
FSC
The IPL switch has been pressed.
IPL Pend
The common controller code is loading; IPL is
Load CC
proceeding.
A cartridge tape is loading.
Loading
Load xxxx, xxxx is an
The load or unload operation failed.
FSC
Fibre Channel firmware is loading; IPL is
Load FIBRE
proceeding.
The tape drive is doing a high-speed seek.
Locating
The IPL failed.
Memory Err
A write-protected tape is in the process of a
NTReady F
manual unload.
A write-enabled tape is in the process of a
NTReady U
manual unload.
Offline alternating
The tape drive is offline.
with *
D-2 StorageTek T10000 Tape Drive Operator's Guide
Recommended Action
Retry the operation, or try another cartridge tape. If
the problem persists, contact authorized service
personnel.
Try another code update cartridge tape.
If the problem persists, contact authorized service
personnel.
Ensure that the data cartridge tape is write-enabled,
or try to reformat the tape on another drive. If the
problem persists, contact authorized service
personnel.
Ensure that the data cartridge tape is write-enabled.
If the problem persists, contact authorized service
personnel.
Retry the operation, or try another cartridge tape. If
the problem persists, contact authorized service
personnel.
Contact authorized service personnel.
Contact authorized service personnel.
Contact authorized service personnel who accesses
the diagnostic data and collects it to tape or to the
host.
IPL the tape drive. If the problem persists, contact
authorized service personnel.
None
Replace the cleaning cartridge.
Contact authorized service personnel.
Contact authorized service personnel.
None
None
None
If the load failed, insert another cartridge tape. If it
loads successfully, suspect the original tape. If
another tape fails to load, IPL the tape drive.
If the problem persists, contact authorized service
personnel.
None
None
Perform the tape drive IPL again. If the problem
persists, contact authorized service personnel.
None
None
None
Advertisement
Table of Contents
