View or Change Configuration Settings
Data Security Erase Mode Submenu
Defaults to the last saved selection.
Full DSE Y writes a random binary pattern on the media, over-writing existing data
from the point of an erase command, to the end-of-tape.
Full DSE N writes data on the media that indicates valid data does not exist beyond
the point of an erase command.
Procedure:
Do one of the following actions:
■
–
–
Drive Address Submenu (FICON only)
Defaults to the last saved selection.
Drv Adr xy
x and y are hexadecimal characters.
■
Establishes the device (not CU) address for the drive. It should usually remain
zero (00). Recheck this address if the link is not operating.
Procedure:
Do one of the following actions:
1.
a.
b.
Press Select to increment the x character until the desired value appears, then
2.
press Menu.
Repeat step 2 for the y character.
3.
Press Menu to advance to the next submenu; or, press Select to restart the change
4.
mode.
Standard Label Overwrite Protection Submenu
Note that Manufacturing ships drives with SL Prot N selected.
4-10 StorageTek T10000 Tape Drive Operator's Guide
Manufacturing ships drives with the Full DSE Y option
Note:
selected.
Press Menu to bypass.
Press Select to toggle; then, press Menu to set and advance to the next
submenu.
Manufacturing ships drives with Drv Adr 00 selected when
Note:
the FICON interface is active.
Press Menu to bypass.
Press Select to start the change mode.
Customers using NL or NSL tape processing cannot use SL
Note:
Prot.