Storagetek Tape Application Accelerator Submenu; Storagetek Maximum Capacity Submenu - Oracle StorageTek T10000 Operator's Manual

–

StorageTek Tape Application Accelerator Submenu

TAA
TAA
TAA
TAA
Defaults to the last saved selection.
Procedure:
Do one of the following actions:
■
–
–

StorageTek Maximum Capacity Submenu

MaxCap ON selects maximum capacity. enables the use of tape capacity that is normally
reserved to ensure tape-to-tape copy operations succeed. Enabling this feature on the
T10000C drive can increase cartridge capacity by five to ten percent.
MaxCap OFF deselects maximum capacity.
Defaults to the last saved selection.
Procedure:
Do one of the following actions:
■
–
–
Press Select to toggle; then press Menu to set and advance to the next
submenu.
If the drive interface type is changed, this parameter is reset to
Note:
the manufacturing (Preset) value.
Manufacturing ships drives with TAA
Note:
N deselects tape application accelerator.
Sync WFM 0 operations will be NOP.
TMK WFM will be place in a buffer.
All WFM0 will be NOP, normal WFM will be placed in a buffer.
Press Menu to bypass.
Press Select to toggle; then press Menu to set and advance to the next
submenu.
If the drive interface type is changed, this parameter is reset to
Note:
the manufacturing (Preset) value.
Manufacturing ships drives with MaxCap OFF selected
Note:
(firmware level 1.57.xxx and higher).
Press Menu to bypass.
Press Select to toggle; then press Menu to set and advance to the next
submenu.
If the drive interface type is changed, this parameter is reset to
Note:
the manufacturing (Preset) value.
View or Change Configuration Settings
N selected.
Menu System 4-13