Update The Firmware; Network Administration; Configuring The Local Area Network Connection (Port 1); Enable Dynamic Host Configuration Protocol (Dhcp) - Oracle StorageTek SL150 User Manual

Network Administration

For installation instructions, see
11.

Update the Firmware

In the Firmware Version field of the Firmware tab, press the Upgrade button.
1.
The Upgrade Firmware dialog appears.
In the Firmware File field of the dialog, press the Choose File button to select the
2.
file that you downloaded in the preceding procedure.
If you accidentally choose the wrong file, press the Clear button to clear the
selection field and press Choose File to make a different selection, or simply press
Choose File to make a different selection.
To leave the existing firmware unchanged and exit without upgrading, press the
3.
Cancel button. When the confirmation dialog appears, press OK.
To install the new firmware, press the Upgrade button.
4.
The upgrade dialog displays a progress meter and the estimated time required for
the upgrade. Do not close this window until the installation process finishes.
When the upgrade dialog shows that the new firmware has been installed, click
5.
the Close this window link. If your browser opens a confirmation dialog, go
ahead and close the window.
When you return to the Firmware tab of the Settings screen, the interface
identifies the newly installed firmware and reminds you that you must restart the
library to activate it.
Restart the library as described in
6.
If you are configuring the library for the first time and need to further configure
7.
the network interfaces, see
If you are configuring the library for the first time and wish to set up partitions,
8.
see
Otherwise, if you are configuring the library for the first time, go to
9.
Drive Cleaning Operations"
Network Administration
You administer network connectivity from the SL150 browser-based user interface.
The Network tab of the Settings screen lets you carry out the following tasks:

Configuring the Local Area Network Connection (Port 1)

■
Enabling and Disabling Service Network Access (Port
■
Configuring the Local Area Network Connection (Port 1)
To configure Ethernet Port 1, you can either:

Enable Dynamic Host Configuration Protocol (DHCP)

■
Assign a Static Network
■
Enable Dynamic Host Configuration Protocol (DHCP)
Log in as an Administrator, and select Settings from the menu on the left side of
1.
the interface. A set of tabbed property sheets appears.
3-4 StorageTek SL150 Modular Tape Library User's Guide
Network Administration
"Partitioning" on page 3-6.
Address.
Update the Firmware.
"Restart the Library"
on page 3-6.
on page 7-3.
below.
"Configuring
2).
or