Table of Contents
Advertisement
View or Change Configuration Settings
Repeat step 2 for each digit.
3.
Press Menu to advance to the next submenu or press Select to restart the change
4.
mode.
Port A/B Soft Physical Addressing Submenu
Appears only with Hard PA N.
Defaults to the last saved selection.
The operator panel window shows:
Soft PA HI the drive seeks a soft PA in an ascending order at loop initialization.
Soft PA LO the drive seeks a soft PA in a descending order at loop initialization.
Procedure:
Do one of the following actions:
■
–
–
Interface Speed Rate Submenu
Selects interface speed rate.
Speed is determined by the network (Rate Auto) or by selecting a fixed rate (varies by
drive model number).
Procedure:
Do one of the following actions:
■
–
–
Rate Auto
Rate 16Gb (T10000D only)
Rate 10Gb (T10000D FCoE only)
Rate 8Gb (T10000D only)
Rate 4Gb
4-6 StorageTek T10000 Tape Drive Operator's Guide
Manufacturing ships drives with Soft PA LO option
Note:
selected. The Solaris default FCP-driver behavior requires a setting
of Soft PA LO.
Press Menu to bypass.
Press Select to toggle; then, press Menu to set and advance to the next
submenu.
Manufacturing ships drives with the Rate Auto option
Note:
selected.
When you select a fixed speed rate, the drive operates at the
Note:
selected rate only. If the network is fixed at a different rate, the
drive does not log on.
Press Menu to bypass.
Press Select until desired option appears; then, press Menu to set and advance
to the next submenu.
Advertisement
Table of Contents
