Table of Contents
Advertisement
View or Change TCP/IP Settings
Gateway Lo Submenu
Operator panel window shows GWlccc.ddd.
Valid entries are 000-255 for each digit trio.
Defaults to the last saved selection.
Procedure:
Do one of the following actions:
1.
a.
b.
For each digit:
2.
a.
b.
If you attempt to enter a value greater than 255 in either trio, all digits flash when
the last digit is set.
Press Menu to advance to the next submenu; or, press Select to restart the change
3.
mode.
Save TCP/IP Submenu
Operator panel window shows Save/IPL ?
This submenu is present if either the DHCP selection or the static TCP/IP settings
were changed.
Saving TCP appears for 2 seconds after you press Select.
After saving the TCP configuration, the drive automatically perform an IPL.
Save Fails appears for RAM problems.
Procedure:
Do one of the following actions:
■
–
–
Exit TCP/IP Submenu
Operator panel window shows Exit TCP ?
This submenu offers you the option to either repeat the TCP/IP submenus or advance
to the next menu.
Procedure:
4-20 StorageTek T10000 Tape Drive Operator's Guide
Manufacturing ships drives with static Gateway Lo set to
Note:
either 000.000. or 255.255
Press Menu to bypass.
Press Select to start the change mode.
Press Select to increment the flashing digit until the desired value appears.
Press Menu to set.
If all digits flash, press either Select or Menu to clear; then,
Note:
press Select to restart the change more.
Press Menu (No) to cancel changes.
Press Select (Yes) to save changes and initiate an IPL.
Advertisement
Table of Contents
