Table of Contents
Advertisement
View or Change Configuration Settings
Do one of the following actions:
1.
a.
b.
Press Select to increment character until desired value appears, then press Menu.
2.
Repeat step 2 for each character.
3.
Press Menu to advance to the next submenu; or, press Select to restart the change
4.
mode.
Port A/B Custom/Normal WWN Submenu
This submenu appears only when the Custom WWN is in use or when one is being
created/edited.
WWN Custom appears whenever a Custom WWN is in use, or is being created/edited.
WWN Custom also appears when the drive is using dynamic WWN, set by a library
invoking dWWN.
Procedure:
Do one of the following actions:
■
–
–
WWN Normal selection recalls the stored normal WWN from the drive EEPROM.
Procedure:
Do one of the following actions:
■
–
–
Port B Attributes Menu
The operator panel window shows either View PrtB ? (online) or Cfg PrtB ?
(offline).
View or change Port B attributes as defined in the preceding port A/B attributes
submenus (see
Procedure:
Press Menu to bypass or press Select to enter the port attributes submenus.
■
Emulation Mode Submenu (FCP)
Procedure:
Do one of the following actions:
■
4-8 StorageTek T10000 Tape Drive Operator's Guide
Press Menu to bypass.
Press Select to start the change mode.
Press Menu to bypass to the next submenu.
Press Select to toggle the selection to WWN Normal.
Press Menu to recall the stored Normal WWN, and advance to the next
submenu.
Press Select to toggle the selection to WWN Custom.
"Port A Attributes Menu"
Manufacturing ships Fibre Channel (FCP) drives with the
Note:
Emul STD option selected. Use the special emulation modes (Emul
9840 and Emul 9940) only at the direction of company technical
support.
on page 4-4).
Advertisement
Table of Contents
