Cable Installation For The Mp-Tp12/15 Back Box; Finalizing The Installation - AMX NXD-1200VG Operation/Reference Manual

Twelve
#6-32
securing
screws
Internal panel casing
Four (pan-head) Housing Screws
FIG. 34 Location of the attachment screws on the NXD back box and VESA housing

Cable Installation for the MP-TP12/15 Back Box

1.
Connect the cable connectors (RJ-45, Ethernet, and any other audio/video wiring) to their respective locations along
the side of the touch panel.
2.
Use the tie-wrap (45-0009A) to wrap the cables together inside the VESA Mount enclosure. This cable tie is used to
insure the cable will not pull through or work itself through the new larger strain relief grommet (45-0032-01) over
time.
3.
Thread the incoming cables through the hole on the rear plastic cover and then through the strain relief grommet.
4.
Slide the grommet along the cable and securely insert it into the opening on the rear plastic cover (FIG. 34).

Finalizing the installation

1.
Gently place the rear plastic cover over the NXD panel (with LCD and MB-TP12/15 back box).
2.
Insert the protruding cables, coming out from the opening on the rear plastic cover, into the open strain relief
grommet.
3.
Allow some slack/length on these cables as a service loop. This service loop provides enough cable length so you
can later remove the NXD (with connected cables) from the rear plastic cover.
VERIFY THE LENGTH AND LOCATION OF THE INSERTED CABLES. ONCE THE
STRAIN RELIEF GROMMET IS CLOSED, IT IS DIFFICULT TO RE-OPEN.
4.
Carefully apply pressure to close the strain relief grommet over the desired cable location.
VG Series Modero Touch Panels
DO NOT REMOVE
Connector
Opening
Securing
hole locations
(3 on each side)
Rear plastic cover
Installation Procedures: 12" and 15" Panels
MB-TP12/15 back box
Strain relief grommet (Clip facing up)
Rim of the strain relief grommet
should lie flush against enclosure
Four (#8-32) screws
45