Installing An Nxt-Bp Into The Nxa-Base/B; Charging The Nxt-Bp Batteries With The Nxa-Base/B - AMX NXD-1200VG Operation/Reference Manual

Touch Panel Accessories
9.
Secure each captive fastener head using a grounded flat-head screwdriver until the NXA-BASE/B is securely
attached to the underside of the NXT Modero touch panel.
10.
Firmly grip the panel LCD/base combo and gently rotate the unit back onto the base.

Installing an NXT-BP into the NXA-BASE/B

The battery base does not directly connect to a power supply, but rather receives its power directly from the Modero
panel, through the Panel Interface connector.
Remove any connectors from the rear of the Modero NXT panel before continuing
with the installation of the batteries. Power can only be supplied after the batteries
have been installed.
1.
With the panel mounted on the battery base, open the battery compartment (FIG. 30) by pulling the handle
outwards. This compartment houses two NXT-BP batteries.
NXT-BP Battery #2
Battery
Compartment
FIG. 30
Battery installation procedure
2.
Install the NXT-BP battery. label-side down.
3.
Align the battery connectors with the corresponding battery connector port (located inside the battery
compartment), as shown in FIG. 30.
4.
Insert the NXT-BP battery until the connectors securely fit into the battery connector port.
5.
Repeat steps 2 through 4 for the other battery.
6.
Apply a small amount of pressure to close the battery compartment until the compartment latches.


Charging the NXT-BP batteries with the NXA-BASE/B

1.
Follow the procedures from the previous sub-section to attach the NXT touch panel to the NXA-BASE/B.
2.
Insert each battery into the battery compartment shown in FIG. 30.
3.
Insert a 2-pin connector from a power supply to the rear PWR connector on the NXT Modero panel.
The charge status bargraph indicators, on the Battery Base page, indicate when the batteries are fully charged.
The NXA-BASE/B will only charge batteries when the NXT panel is in Sleep mode.
40
Battery
Connector
Port
Battery #2
slot
After a few seconds, the panel will turn On and the AMX logo will appear (indicating the panel is receiving
power.
Battery
Connectors
Interface
connector
FRONT
NXT-BP Battery #1
VG Series Modero Touch Panels