VG-Series Modero Connectors
FIG. 1 shows the connectors on the VG-Series Modero panels.
NXT VG-Series
connectors located on
rear panel of the base
Composite/RGB
and pass-thru
control (CAT5)
FIG. 1
Connector layout on sample VG-Series Video Touch Panels (RGB connector available with RGB Kit)
Connecting and Using USB Input Devices
These panels can have up to two USB-capable input devices connected for use both on its different firmware and TPD4
panel pages. These input devices can consist of a keyboard or mouse.
USB-connected input devices are detected and recognized by the panel upon
connection. Refer to the Configuring and Using USB with a Virtual
Master section on page 81 for more information on using a USB connection.
1.
Insert the input device USB connectors into the appropriate USB connector on the panel.
2.
Press the on-screen Reboot button (Protected Setup page) to save any changes and restart the panel.
3.
After the panel splash-screen disappears:
If a USB mouse has been connected, a mouse cursor appears on the panel screen and its location corresponds
to the mouse cursor position sent by the external USB mouse.
If a USB keyboard has been connected, only on-screen keyboards and keypads will reflect any external
keystrokes sent from the external USB keyboard.
Cleaning the Touch Overlay
You should clean the touch screen overlay after each day's use.
Always use clean cotton cloths and a spray bottle containing water.
VG Series Modero Touch Panels
RGB
A
RGB
AUDIO/VIDEO
ETHERNET
Audio-Video from
Ethernet
NXA-AVB/RGB
(CAT5)
(CAT5)
L
12VDC
PWR
Stereo
Keyboard/Mouse
Output
Power
USB connectors (2)
Introduction
NXD VG-Series
connectors located
on left side panel
PROGRAM
Mini-USB
(Program Port)
11