Wiring Guidelines For The 1700Vg Panels; Preparing Captive Wires - AMX NXD-1200VG Operation/Reference Manual
Vg series modero 12" / 15"/ 17"
Hide thumbs
Also See for NXD-1200VG:
- Datasheet (3 pages) ,
- Quick start manual (2 pages) ,
- Dimension manual (1 page)
Table of Contents
Advertisement
Installation Procedures: 17" Panels
FIG. 62
NXD-1700VG Wall Mount panel installed into an NXA-RK17 Rack Mount Kit
7.
Secure the panel to the NXA-RK17 mount frame by first inserting and then tightening the four
#4-40 screws.
8.
Insert the NXA-RK17 (with connected NXD unit) into the equipment rack, making sure to align the screw holes
along the sides of the NXA-RK17 with the holes in the equipment rack.
9.
Use a grounded Phillips-head screwdriver to secure the NXA-RK17 to the equipment rack using #10-32 screws (not
included).
10.
Place the magnetic faceplate back onto the main NXD unit by gripping the faceplate and placing it on the housing
with gentle force. Make sure to align the Microphone, Light, and PIR Motion sensor locations to their respective
openings on the front bezel/faceplate.
11.
Reconnect the terminal RJ-45, Ethernet, and any optional audio/video wiring to their respective terminal locations
on either the NXA-AVB/RGB Breakout Box, Ethernet port, or NetLinx Master.
12.
Reconnect the terminal power connector on the 12 VDC-compliant power supply and apply power.
Wiring Guidelines for the 1700VG Panels
1700VG panels use a 12 VDC-compliant power supply to provide power to the panel via the 2-pin 3.5 mm mini-Phoenix
PWR connector. Use the previously referenced power requirements to determine the power draw.
The incoming PWR and GND wires from the power supply must be connected to the corresponding locations within the
PWR connector.
These units should only have one source of incoming power. Using more than one
source of power to the touch panel can result in damage to the internal components
and a possible burn out.
Apply power to the panels only after installation is complete.
Preparing captive wires
You will need a wire stripper and flat-blade screwdriver to prepare and connect the captive wires.
Never pre-tin wires for compression-type connections.
1.
Strip 0.25 inch (6.35 mm) of insulation off all wires.
74
482.60
19.00
399.29
15.72
84.03
3.31
VG Series Modero Touch Panels
Advertisement
Table of Contents
