Cable Installation For The Mp-Tp12/15 Back Box; Finalizing The Installation - AMX NXD-1700VG Instruction Manual

Cable Installation for the MP-TP12/15 Back Box

1. Connect the cable connectors (RJ-45, Ethernet, and any other audio/video wiring) to their respective locations along the side
of the touch panel.
2. Use the tie-wrap (45-0009A) to wrap the cables together inside the VESA Mount enclosure. This cable tie is used to insure the
cable will not pull through or work itself through the new larger strain relief grommet (45-0032-01) over time.
3. Thread the incoming cables through the hole on the rear plastic cover and then through the strain relief grommet.
4. Slide the grommet along the cable and securely insert it into the opening on the rear plastic cover (FIG. 34).

Finalizing the Installation

1. Gently place the rear plastic cover over the NXD panel (with LCD and MB-TP12/15 back box).
2. Insert the protruding cables, coming out from the opening on the rear plastic cover, into the open strain relief grommet.
3. Allow some slack/length on these cables as a service loop. This service loop provides enough cable length so you can later
remove the NXD (with connected cables) from the rear plastic cover.
NOTE: VERIFY THE LENGTH AND LOCATION OF THE INSERTED CABLES. ONCE THE STRAIN RELIEF GROMMET IS CLOSED, IT IS
DIFFICULT TO RE-OPEN.
4. Carefully apply pressure to close the strain relief grommet over the desired cable location.
NOTE: Verify the Strain Relief Grommet is securely closed over the cables and the clip is facing the correct direction (upwards).
The process of securing the strain relief grommet may require the use of pliers. Also verify the length and location of the inserted
cables. Once the strain relief grommet is closed, it is diff icult to re-open.
5. Firmly push the Strain Relief Grommet into the opening (toward the inside) until the rim is securely flush against the back of
the rear plastic cover (FIG. 34).
6. Securely grasp both sides of the NXD panel (with LCD, MB-TP12/15 back box, and attached cables), rotate the entire unit over,
and lie it on a flat level surface.
7. Note the available mounting contact surface area on the rear plastic cover of the MB-TP12 (FIG. 35) and MB-TP15 (FIG. 36).
This area represents the space available for use with a VESA connector plate.
.80[20MM]
2.52[64MM]
3.55[90MM]
MB-TP12 Mounting contact surface area
FIG. 35
.72[18MM]
3.83[97MM]
4.52[115MM]
MB-TP15 Mounting contact surface area
FIG. 36
Modero VG Series Touch Panels - Instruction Manual
2.61[66MM]
3.23[82MM]
Installation Procedures: 12" and 15" Panels
46