Step 3: Install The Nxa-Rgb Card Component (Nxt) - AMX NXD-1200VG Operation/Reference Manual

Touch Panel Accessories
FIG. 18 Installation of the mini-PCI card connector on main board
7.
Locate the terminal ends of the antennas and apply downward pressure to "snap" them onto their gold-tipped
counterparts on the mini-PCI card (FIG. 18). Carefully push down on each connector to verify it is securely joined
to the card.
It is recommended that any upgrade of internal equipment be done simultaneously in
order to reduce the risk of damage to internal components.
If you are also installing an NXA-RGB card (as part of an NXA-RGBKIT), refer to the
installation procedures on page 16 before replacing the outer housing.

Step 3: Install the NXA-RGB Card Component (NXT)

1.
Discharge any static electricity from your body by touching a grounded metal object.
2.
Locate the RGB card's slot connector on the main board and align it with its counterpart on the bottom of the NXA-
RGB card.
3.
Carefully, but firmly, insert the NXA-RGB card into the RGB connector slot on the main board until both the card
rests atop the four raised securing holes and the RGB RJ-45 connector is evenly aligned with the other RJ-45
connectors on the back of the panel.
4.
Use a grounded Phillips-head screwdriver to secure the four NXA-RGB pan-head securing screws to the raised
securing holes on the main board.
NXA-RGB card
NXA-RGB card
screw locations (4)
RGB I/O
connector plate
FIG. 19
Location of the NXA-RGB card and I/O plate
5.
To complete the upgrade process, either upgrade the remaining component (Step 3) or close and re-secure the
enclosure using the procedures in Step 5: Close and Resecure the NXT Panel Enclosure section on page 34.
32
Antennas connectors
Connection point
between the braces and
the mini-PCI card
Outer Housing
VG Series Modero Touch Panels