Step 2: Install The New 802.11G Mini-Pci Wireless Card (Nxd); Step 3: Install The New Rgb Card Component (Nxd); Step 4: Install The New Compact Flash Memory Card (Nxd) - AMX NXD-1200VG Operation/Reference Manual

DO NOT
REMOVE
these
panel
securing
screws
FIG. 22 Location of the securing screws on an NXD panel

Step 2: Install the new 802.11g mini-PCI Wireless card (NXD)

Complete the procedures outlined within Step 2: Install the 802.11g mini-PCI Wireless Card section on page 31 and then
continue with the following step.

Step 3: Install the new RGB Card Component (NXD)

1.
Discharge any static electricity from your body by touching a grounded metal object.
2.
Locate the RGB card's slot connector on the main board and align it with its counterpart on the bottom of the
NXA-RGB card.
3.
Carefully, but firmly, insert the NXA-RGB card into the RGB connector slot on the main board until both the card
rests atop the four raised securing holes and the RGB RJ-45 connector is evenly aligned with the other RJ-45
connectors on the back of the panel.
4.
Use a grounded Phillips-head screwdriver to secure the four NXA-RGB pan-head securing screws to the raised
securing holes on the main board. Refer to the Step 3: Install the NXA-RGB Card Component (NXT) section on
page 32 for more information.

Step 4: Install the new Compact Flash Memory card (NXD)

Complete the procedures outline within Step 4: Install the Compact Flash Memory Card upgrade section on page 33 and
then continue with the following step.
VG Series Modero Touch Panels
DO NOT REMOVE
these panel
securing screws
Unscrew these four Housing Screws
to remove the back box.
These make direct contact with the black
outer housing.
Touch Panel Accessories
35