Installation Procedures: 17" Panels
DO NOT
REMOVE
these
panel
securing
screws
FIG. 50
Location of the attachment screws on the NXD back box
DO NOT REMOVE THE FOUR PANEL SECURING SCREWS. These screws secure
the LCD to the metallic casing underneath.
7.
Lift the back box housing to separate it from the internal panel casing.
Installing the MP-TP17 Back Box
1.
Unscrew the four pan-head Housing Screws (#8-32) from the MB-TP17 rear plastic cover.
2.
Gently place the MB-TP17 back box over the internal panel casing (with the cable routing hole on the right-side of
the panel).
3.
Re-install and secure the four pan-head Housing Screws into their pre-drilled holes along the edges of the MB-TP17
back box (FIG. 51) and secure them using a grounded Phillips-head screwdriver.
4.
Place the I/O connector plate back over the connector opening and align the connector locations.
5.
Resecure the I/O connector plate (using a grounded Phillips-head screwdriver) and resecure the Stereo Output nut
on the Stereo Output jack.
60
Unscrew these four Housing Screws to
remove the back box. These make direct
contact with the black outer housing.
DO NOT REMOVE
these panel
securing screws
VG Series Modero Touch Panels