Installing The Nxd Into Drywall Using Expansion Clips - AMX NXD-1200VG Operation/Reference Manual

Installation Procedures: 12" and 15" Panels

Installing the NXD into drywall using Expansion Clips

Expansion clips are mounted through the four oval holes located at the top and bottom of the panel. As the screw is
tightened, the clip bends toward the insertion hole and into the wall. This bending creates a "grip" on the wall by either
pressing onto the wall or by securing the drywall between the housing and the drywall clip.
The most important thing to remember when mounting the NXD is that the outer frame (Mounting Tabs) must be
installed flush against the mounting surface.
It is recommended to cutout the surface slightly smaller than what is outlined in the
installation drawings so that you can make any necessary cutout adjustments.
1.
Prepare the area by removing any screws or nails from the drywall before beginning the cutout process.
2.
Cut out the surface for the 12-inch Wall Mount using the dimensions shown in FIG. 40 and for the 15-inch Wall
Mount using the dimensions shown in FIG. 41. Be sure to cut out the four notches along the top and bottom areas to
accommodate the four drywall expansion clips (provided).
FIG. 40 NXD-1200VG 12-inch Wall Mount panel dimensions using expansion clips
3.
Remove the magnetic faceplate/bezel (A in FIG. 42) from the main NXD unit (B in FIG. 42) by gripping the
faceplate and pulling with gentle outward force.
50
CUTOUT
FRONT BEZEL
VG Series Modero Touch Panels