Changing The Installation Position Of The Caster Wheels - Otto Bock Zenit Instructions For Use Manual

29

6.3.2 Changing the installation position of the caster wheels

INFORMATION
The adjustments described below may not be carried out on the CLT or CLT Ultra model.
INFORMATION
Please refer to the seat height table in the technical data.
The front seat height is adjusted using the row of holes in the fork and the diameter of the caster wheels.
1) Loosen the screw connection on the threaded sleeve (see fig. 31).
2) Remove the threaded sleeve and spacer bushings.
INFORMATION: Note that the illustrated and described spacer bushings are not present with all
offered caster wheels.
3) Remove the caster wheel.
4) Insert the threaded sleeve (see fig. 32, item 1) into the desired hole in the fork and slide on the first spacer
bushing (see fig. 32, item 2) from the inside.
5) Install the caster wheel (see fig. 32, item 3).
6) Push on the second spacer bushing (see fig. 32, item 4).
7) Insert the mounting screw (see fig. 32, item 5) and tighten the threaded sleeve to 8 Nm.
→ Once changed, the left and right caster wheels must have the same vertical position in the caster fork.
→ After changing the front seat height, always check the caster wheel journal angle and adjust it if necessary (see
Page 15).
31
Zenit
30
32
Settings
17