Icom IC-7600 Instruction Manual page 134

Memopad Numbers
Sets the number of memo pad channels avalable.
5 or 10 memo pads can be selected. (default: 5)
MAIN DIAL Auto TS
Sets the auto tunng step functon for the man dal.
When rotatng the man dal rapdly, the tunng step
automatcally changes several tmes as selected.
There are 2 type of auto tunng steps: HIGH
(Fastest) and LOW (Faster). (default: HIGH)
MIC Up/Down Speed
Sets the rate at whch frequences are scanned
when the mcrophone [UP]/[DN] swtches are
pushed and held. HIGH or LOW can be selected.
Quick RIT/∂TX Clear
Selects the RIT/∂TX frequency clearng nstructon
wth [CLEAR]. (default: OFF)
[NOTCH] Switch (SSB)
Selects notch functons for SSB mode operaton
from Auto, Manual and Auto/Manual.
(default: Auto/Manual)
[NOTCH] Switch (AM)
Selects notch functons for AM mode operaton from
Auto, Manual and Auto/Manual.
(default: Auto/Manual)
SSB/CW Synchronous Tuning
Selects the dsplayed frequency shft functon from
ON and OFF. (default: OFF)
When ths functon s actvated, the audo ptch or
tones of the receved sgnal wll reman the same
even when the operatng mode s changed between
SSB and CW.
The amount of frequency shft may dffer accord -
ng to the CW ptch settng.
5
HIGH
• HIGH : Approx. 5 tmes faster when the tun-
ng step s set to 1 kHz or smaller steps;
approx. 2 tmes faster when the tunng
step s set to 5 kHz or larger steps.
• LOW : Approx. 2 tmes faster
• OFF : Auto tunng step s turned OFF.
HIGH
• LOW : Low speed (25 tunng steps/sec.)
• HIGH : Hgh speed (default; 50 tunng steps/sec.)
OFF
• OFF : Clears the RIT/∂TX frequency when [CLEAR]
s pushed and held for 1 sec.
• ON : Clears the RIT/∂TX frequency when [CLEAR]
s pushed momentarly.
Auto/Manual
• Auto : Only the auto notch can be used.
• Manual : Only the manual notch can be used.
• Auto/Manual : Both the auto and manual notch can
be used. (default)
Auto/Manual
• Auto : Only the auto notch can be used.
• Manual : Only the manual notch can be used.
• Auto/Manual : Both the auto and manual notch can
be used.
OFF
• OFF : The dsplayed frequency does not shft.
• ON : The dsplayed frequency shfts when the
operatng mode s changed between SSB
and CW.
☞ Contnues to the next page.
10
SET MODE
132
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21